Sony Micro Hi-Fi System with Giga Juke Hard Drive NAS-50HDE Benutzerhandbuch

NAS-50HDE.GB.2-890-157-11(1)

Select [Network status check] in the wired 
LAN setup display.

Select [Execute].
The unit starts checking the network status.

When the unit finishes checking, [OK] or [NG] 

appears for each item. It may take for a few 

minutes until the unit finishes checking.
•  If [OK] appears for all items, go to step 5.
•  If an [NG] appears, go to step 3.

Select [Details] for items marked by an [NG].
The display shows the assumed cause of the 

problem.

After reading the cause in step 3, follow the 
instructions that appear in the display to 
make the settings again, and then repeat 
steps 2 and 3 until the [NG] changes to [OK].
In certain network environments, such as an 

office LAN, [NG] may appear even though all 

connections and settings are correctly made. In 

this case, contact the network administrator.

Select [Close].
The display returns to the network setting display.

Select [Close] or press BACK.
The network setting display closes.

Enter the Setup menu and select [Network].

Select [LAN] – [Wireless].

Select [Wireless LAN setting].

Select [Access point setting] – [Search for 

available access point.].
Select the access point from the search 

results.

Set the SSID, security setting and network 

key, and then select [Save].

Select [Close]
The display returns to the wireless LAN 

access point setting display.

Select [Close].
The display returns to the wireless LAN 

setting display.

After this procedure, do the IP address and 

proxy server settings (shown below).

You can manually set the access point in step 4.

After you set the access point, you have to do the IP 

address and proxy server settings. Do the procedure 

from step 4 of “To set up a wired LAN network” 

(page 92) to make these settings (only the necessary 

items for the wireless LAN setting appear). If 

these settings are made automatically, confirm the 

contents and select [Apply].

If you have disconnected the USB adaptor after 

setting these items, enter the Setup menu again, 

select [Network] – [Wireless LAN setting] 

– [Address setting], and then select [Apply].