Hoover hoover dishwasher Benutzerhandbuch

Seite von 32
30
N.B.: 
Should any of the situations occur and should the machine give a bad wash performance,
it is necessary to remove the deposits from the dishes by hand since the final drying cycle hardens the
deposits which a second wash in the machine would not be able to remove.
If the malfunction continues contact a Service Centre quoting the serial number of the dishwasher.
This is found on the plaque on the inside of the dishwasher door at the top or on the guarantee. 
This information will make it possible to take more effective action more quickly.
The manufacturers decline any responsibility for any printing mistakes in this instruction booklet.
They also reserve the right to modify their own appliances as necessary without altering the
essential characteristics.
FAULT
CAUSE
REMEDY
7 - Load of dishes is only 
partially washed 
8 - Detergent not dispensed
or partially dispensed
9 - Presence of white spots 
on dishes
10 - Noise during wash
11 - The dishes are not 
completely dry
See causes for no. 5
Bottom of saucepans have not
been washed well
Edge of saucepans have not 
been washed well
Spray arms are partially blocked
The dishes have not been 
properly loaded
The end of the outlet hose is in
the water
The incorrect amount of 
detergent has been measured
out; the detergent is old and hard
The wash programme is not 
thorough enough
The lower basket dishes have
not been washed
Cutlery, dishes, pans, etc... stop
the detergent dispenser opening
Water is too hard
The dishes knock against one
another
The revolving arms knock against
the dishes
Inadequate air flow
Rinse aid missing
Check
Burnt on food remains must 
be soaked before putting pans
in dishwasher
Reposition saucepans
Remove spray arms by
unscrewing ring nuts clockwise
and wash under running water
Do not place the dishes too 
closely together
The end of the outlet hose 
must not come into contact 
with the outflow water
Increase the measure 
according to how dirty the
dishes are and change detergent
Choose a more vigorous 
programme
Depress half load button
Position dishes not to obstruct
the dispenser 
Check salt and rinse aid level
and regulate amount. 
Should the fault persist, 
Contact Service Centre
Re-check loading of dishes in
the basket
Again re-check loading
Leave the dishwasher door ajar
at the end of the wash program
to allow the dishes to dry naturally
Fill the rinse aid dispenser