Keating Of Chicago 1-800 Benutzerhandbuch

A. PREPARING THE FILTER-DRAWER

CAUTION

WATER IN ANY FORM & HOT OIL DON'T MIX!

NOTE: Operator should be outfitted with proper

protective attire: safety goggles, oil and heat

resistant gloves, apron and footwear

Filter assembly inside of cabinet:
1. Pull the handle marked “Pull to Release Filter”

(top of filter panel).

2. Remove the entire assembly from the cabinet by rolling it

forward.

3. Pull the handle marked “Pull to Release Tub”

(bottom of panel)

4. Slide the tub back, lift up and remove from cart.
5. Ensure all components are clean

(NOTE: Filter tub and components are dishwasher safe).

6. Install components into tub as follows:

a. Sump screen

b. Filter paper

c. Hold down ring (Note 1)

d. Acidox (1 package per 40lbs oil) (Note 2)

e. Crumb basket

See Figure 1

NOTE 1: Hold down ring makes a gasket-like seal on filter

paper. Filter paper must be placed edge to edge from front to

back, overlapping on sides. Filter Paper must be smooth and

flat under hold down ring to get a proper seal. Lock the two

tension arms into place by pushing down and rotating 90°.
NOTE 2: One package of Acidox is needed for every 40

pounds of oil.
7. Place entire tub assembly onto the cart (NOTE: Ensure

the lip on the tub goes under the cart frame in the rear).

8. Reconnect the tub to the motor by pulling together the

handles on the front of the tub and the handles on the

side of the motor housing.

See Figure 2

NOTE: Push on the front of the tub to verify connection. If tub

moves, repeat steps 7-8.

SAFE & EASY

FILTER

OPERATING INSTRUCTIONS

KEEP THIS MANUAL FOR TRAINING NEW PERSONNEL

– 1 –

CRUMB

BASKET

FILTER

TUB

HOLD

DOWN RING

FILTER

PAPER

SUMP

SCREEN

SPRINKLE ACIDOX EVENLY ON PAPER

FIGURE 1.

FIGURE 2.

Pull handles

to connect

tub to

pump

Motor Housing