Keating Of Chicago 1-800 Benutzerhandbuch

Connect hose here to discard oil

– 4 –

1. Read and follow the filtering procedure.

2. Always verify 2 connections are engaged 

when filtering.

• Quick disconnect under the tub to the 

motor housing.

• Quick disconnect on top of the motor 

housing to the fryer or central filter quick 

disconnect.

3. Stir the oil completely before draining.

4. Place the sump screen under the filter paper.

5. Change the filter paper for each fryer filtered.

1. Run water through the pump.

2. Filter oil without wearing the proper attire.

3. Filter cold oil (must be between 250°- 350°).

4. Use the 6 foot hose to clean the fry tank (hose

should only be used to discard the oil).

5. Powerwash, spray, or hose down the motor 

housing area, as electrical components are 

present.

4. Push the small black knob on the filter panel to the left 

(“Oil to Hose”).

5. Place the nozzle of the hose in an approved discard 

container.

6. Drain the oil.
7. Plug the filter into the receptacle.
8. Turn the motor switch ON (the green light will illuminate).

9. Turn the motor switch “OFF”.

10. Push the small black knob on the filter panel to the 

right (“Oil to Fryer”).

11. Close drain valve of the fryer (large black knob).

12. Hose can be removed by pulling the handle on the left

of the motor housing.

13. Prepare filter tub for next useage (see section A).

14. Clean excess oil from wand and quick disconnect on the 

hose.

Pump must be primed with oil after boil-out with water.

Failure to lubricate pump may cause severe damage to Filter

System and void the warranty.