AEG 2003 F Benutzerhandbuch

Installing and Connecting

36

1 

Important: Assembly and connection of the new appliance may only 
be performed by an approved installer. 

Please observe this instruction, otherwise the warranty will not cover 
any damage that may occur. 

• The veneer or plastic coverings on kitchen furniture around the 

appliance must be bonded with heat resistant adhesive (100 °C). If 
plastic coverings or the adhesive are not sufficiently temperature 
resistant, then the covering may distort or come loose. 

• In respect of fire protection, this appliance corresponds to type Y 

(EN 60335-2-6). Only this type of appliance may built into positions 
with a high cupboard or wall on one side. 

• The separation between the hob and the extractor hood must be at 

least as large as that given in the extractor hood installation instruc-
tions. 

Underneath the appliance there 
are 4 adjustable feet with the aid 
of which you can compensate for 
small amounts of unevenness in 
the floor. 

0 

1. Remove the utensils drawer

2. Turn the adjustable feet to raise 

or lower them until the cooker is 
level. 

3. Replace the utensils drawer. 

3 

The adjustable feet are easier to 
turn if the cooker is tilted slightly 
to take the load off the feet. 

+

_

+

_