AEG FM 4803K-AN Benutzerhandbuch
30
To ensure the necessary air supply to
the appliance, the top of any floor
cupboard must be removed. If this is
not done, the air supply will be cor-
respondingly reduced and the guar-
antee will be invalid.
The distance between the lower sur-
face of the appliance and
shelves/drawers must be min. 20
mm.
the appliance, the top of any floor
cupboard must be removed. If this is
not done, the air supply will be cor-
respondingly reduced and the guar-
antee will be invalid.
The distance between the lower sur-
face of the appliance and
shelves/drawers must be min. 20
mm.
If the appliance is installed with a
base shelf underneath, two cutouts
must be created in the shelf - one at
the front and one at the rear - to pro-
vide sufficient ventilation to the
electrical components.
The cutouts must be min. 10x250
mm.
base shelf underneath, two cutouts
must be created in the shelf - one at
the front and one at the rear - to pro-
vide sufficient ventilation to the
electrical components.
The cutouts must be min. 10x250
mm.
If the appliance is installed with an
oven located below it, there must be
no intervening shelf/panel.
The distance between the top of the
worktop and the top of the oven
must be min. 60 mm (thus ensuring
that the distance between the top of
the oven and the lower surface of the
appliance is greater than 20 mm.
oven located below it, there must be
no intervening shelf/panel.
The distance between the top of the
worktop and the top of the oven
must be min. 60 mm (thus ensuring
that the distance between the top of
the oven and the lower surface of the
appliance is greater than 20 mm.
Installation in cupboard
WITHOUT oven
WITHOUT oven
Installation in cupboard
WITH oven
WITH oven
15
Automax
With AUTOMAX you do not need
to turn down the temperature. When
using AUTOMAX the zone gets full
heat for a certain amount of time
where after the cooking zone auto-
matically adjusts to the setting you
have chosen.
to turn down the temperature. When
using AUTOMAX the zone gets full
heat for a certain amount of time
where after the cooking zone auto-
matically adjusts to the setting you
have chosen.
To adjust AUTOMAX you have to
do the following:
do the following:
1. Turn on the hob, push
k
.
2. Adjust the desired cooking zone
at the setting you wish to use.
3. Push
N
.
When AUTOMAX is coded the con-
trol lamp for “A” will light up.
trol lamp for “A” will light up.
To turn off AUTOMAX, you have to
push
push
N
.
The “AUTOMAX” chart on the fol-
lowing page gives guidelines for
suitable heat settings for different
types of cooking.
lowing page gives guidelines for
suitable heat settings for different
types of cooking.