Alamo 803213C Benutzerhandbuch
ASSEMBLY
INTERSTATER 03/09
Assembly Section 3-5
© 2009 Alamo Group Inc.
ASSEMBL
Y
5. Lift the rear of the frame and secure with (4) 1/2" x 1 1/2" & (2) 5/8" x 1/3/4" bolts. Install the remaining front
hardware. ASM-FL-0006
MOUNTING AND PUMP ASSEMBLY
1.
Before mounting tank, attach pipe manifold for
return lines to the return filter assembly.
2.
Raise bumper with a forklift or hoist and lower
onto hydraulic tank supports. Attach the bumper
to the tank supports with (4) 1/2” x 2" bolts and
(4) 1/2" locknuts. ASM-FL-0007
to the tank supports with (4) 1/2” x 2" bolts and
(4) 1/2" locknuts. ASM-FL-0007
3.
Now tighten all hardware for mainframe, tank
support, tank, and bumper.
LIFT CYLINDER FRAME ATTACHMENT
Position the right and left lift cylinder supports and
loosely install the (6) 3/4" x 2-1/4" bolts and (6) 3/4"
locknuts to each side. Pull the supports outward and
downward to remove the slack, then tighten the
hardware. ASM-FL-0008
loosely install the (6) 3/4" x 2-1/4" bolts and (6) 3/4"
locknuts to each side. Pull the supports outward and
downward to remove the slack, then tighten the
hardware. ASM-FL-0008
NOTE: On some applications Cylinder Support will
have an extra set of holes. Refer to Installation
Drawing for correct mounting.
have an extra set of holes. Refer to Installation
Drawing for correct mounting.