Panasonic SD-YD250 Benutzerhandbuch

Seite von 36
- 14 -
TEMP
ALERT
Reason/Cause
Condition
Motor protection device
Remedy 2
There has been a 10-minute or 
less power cut. (The power plug 
has been inadvertently pulled out or 
the breaker has activated.) 
Or there has been a slight change in
the power supplied to the machine.
How to reset/restart
If the interruption in the power supply is 
momentary, the operation will not be affected.
If the power is restored within 10 minutes, the 
bread maker will operate again. However, the 
bread may not turn out well.
Remove the dough and start again using all 
new ingredients.
Not baked at all, although 
the operation appears to 
have proceeded.
Check to see if the kneader mounting shaft can 
rotate.  
Motor protection device has activated. 
This only happens when the unit is 
overloaded and an excessive force 
is applied to the motor. 
After about 30 minutes, the motor
automatically starts running again.
If the unit is overloaded and an excessive force is applied to the motor, the protection device will
stop the motor. After approximately 30 minutes, the motor will automatically start running again. It is
recommended to restart with fresh ingredients.
If the kneading blade is restricted by hard dough, take out the dough. The
unit will restart 30 minutes later.
Check to see if the kneader mounting shaft of the bread pan can rotate.
If it can rotate, restart the bread maker after 30 minutes. If it cannot rotate,
service will be required.
Make sure you did not use 
too much or too hard/heavy 
ingredients, then start again 
using all new ingredients.
Service will 
be required.
is on 
display.
is on 
display.
 
appears 
on
display.