GE r10279v Benutzerhandbuch

7

IMPORTANT –

 Save these instructions

for local inspector’s use.

IMPORTANT –

 Observe all governing codes

and ordinances.

– Be sure to leave these

instructions with the Consumer.

Note to Consumer 

– Keep these instructions

with your Owner’s Manual for future reference. This kit
provides a stainless steel tubular handle to coordinate
with other Monogram appliances.

• The tubular handle must be installed onto the 3/4

″ thick

portion of the custom wood panel before the panel is
secured to the door.

• Gloves to protect against sharp edges
• #2 Phillips screwdriver
• Drill and 1/4

″ bit and 1/2″ spade bit

• Safety glasses
• Center punch
• Pencil

• Tubular handle
• 2 Mounting screws
• 2 Handle standoffs
• 2 Set screws for standoffs
• 2 Nuts
• 2 Washers
• Allen Wrench

• Use the handle as a template to locate and mark the

exact position of the screw holes. Be careful to avoid
interference with custom panel mounting screws.

• Draw a pencil line, top to bottom and 7/8

″ from the

outside edge.

• Hold the tubular handle against the appearance side,

centered on the marked line.

• Mark the screw hole locations at the center of the

handle attachment posts.

• Center punch the marked hole locations. Drill 1/4

″

pilot holes from the appearance side through the
entire panel thickness.

• Use a 1/2

″ spade bit to drill 1/4″ to 5/16″ deep into

the back side of the panel. Insert washer (spacer) into
the hole.

• Install screw through the handle standoff and into the

pilot hole.

• Fasten nut onto the screw until the standoff is tight

against the panel. The screw hole on the standoff
should be pointing down toward the floor.

• Place handle attachment posts inside the standoffs.
• Use the Allen wrench to install the set screws. Tighten

handle to standoffs.

Handle
Standoff

Handle
Attachment
Post

Tubular
Handle

Screw

Set
Screw

Washer

Nut

Custom
Framed
Panel

30”

24-7/32”

7/8”