Smeg LBS 635 Benutzerhandbuch

13

13

At the end of the water inlet valves which 

are  mounted  to  the  back  of  the  machine 

and  the  flat  end  of  the  water  inlet  hoses 

that  are  mounted  onto  the  taps,  there  is 

one  filter  for  each.  These  filters  prevent 

the  foreign  substances  and  dirt  in  the 

water entering the machine. Filters should 

be cleaned when they get dirty. To do this, 

close  the  taps.  Remove  the  water  inlet 

hoses. Clean the tops of the filters on the 

water  inlet  valves  with  a  thin  brush.  If  the 

filters  are  very  dirty,  you  can  pull  out  with 

pliers  and  clean  them.  The  filters  on  the 

flat  end  of  the  water  inlet  hoses  should 

be  taken  out  with  their  gaskets  by  hand 

and  cleaned  thoroughly  under  the  flowing 

water.  (There  are  2  filters  in  the  machines 

with single (cold) water inlet and 4 filters in the 

machines with double (hot-cold) water inlets.

The powder detergent remnants may 

accumulate in the detergent drawer. 

To clean the detergent drawer, pull the 

drawer towards you by pressing the 

marked point of the siphon in the softener 

compartment as shown in the illustration. 

Wash the drawer in the sink with plenty of 

water.

Do not forget to clean the siphon 

(the colored part in the detergent drawer) 

when it gets dirty. To remove the siphon, 

first take out the detergent drawer. To 

prevent clogging, clean the softener 

remnants inside of it. After cleaning, put 

back the siphon and check if it is well 

seated or not.

Since there is a risk of freezing especially 

in the cold areas, the water remaining in 

the appliance can frozen and damage the 

appliance. In this case, the water 

remaining in the pump and hoses should 

be drained by removing the pump filter. 

Water inlet hoses should also be emptied 

by removing them from the taps.