Jenn-Air JBC7624BS Benutzerhandbuch
12
To Clean Milk Frother:
1. “PRESS CLEAN BUTTON” will be displayed.
2. Place a container under the milk spout.
3. Press and hold CLEAN on the milk container lid for at least
2. Place a container under the milk spout.
3. Press and hold CLEAN on the milk container lid for at least
8 seconds.
4. “CLEANING” and a progress bar will be displayed. Do not
release CLEAN until the progress bar is complete and
cleaning has ended. The Clean cycle will stop when the Clean
button is released.
cleaning has ended. The Clean cycle will stop when the Clean
button is released.
5. After cleaning, remove the milk container. Push the spout
down against the container and place it in the refrigerator. Do
not leave milk out of the refrigerator for more than
15 minutes.
not leave milk out of the refrigerator for more than
15 minutes.
To Clean Hot Water and Steam Nozzle:
Use a damp sponge or cloth to clean the hot water and steam
nozzle after each use.
nozzle after each use.
To Change the Amount of Milk and Coffee:
The coffee system is factory-set to automatically deliver a 1 cup
(225 mL) cappuccino. The amount of milk and coffee used can be
custom-set.
1. Fill the milk container with milk to the MAX level.
2. Place a cup under the coffee and milk spouts.
3. Press and hold the Cappuccino button until “PROGRAM
(225 mL) cappuccino. The amount of milk and coffee used can be
custom-set.
1. Fill the milk container with milk to the MAX level.
2. Place a cup under the coffee and milk spouts.
3. Press and hold the Cappuccino button until “PROGRAM
QUANTITY Milk for Cappuccino” is displayed. The coffee
system will dispense milk.
system will dispense milk.
4. Press the Cappuccino button again to stop the milk runoff and
save the desired amount of milk for the default setting.
5. After a few seconds, the coffee system will begin dispensing
coffee. “PROGRAM QUANTITY Coffee for Cappucc.” will be
displayed.
displayed.
6. Press the Cappuccino button again to stop the coffee runoff
and save the desired amount of coffee for the default setting.
Dispensing Hot Water
The coffee system can dispense hot water without brewing
coffee. Make sure the hot water spout is attached to the hot
water and steam nozzle and that the coffee system is ready for
use.
1. Place a container under the hot water spout.
2. Press HOT WATER.
3. “HOT WATER Press OK” will be displayed. Press OK.
4. “HOT WATER” will be displayed, and hot water will run out of
coffee. Make sure the hot water spout is attached to the hot
water and steam nozzle and that the coffee system is ready for
use.
1. Place a container under the hot water spout.
2. Press HOT WATER.
3. “HOT WATER Press OK” will be displayed. Press OK.
4. “HOT WATER” will be displayed, and hot water will run out of
the spout.
NOTE: Do not run hot water for more than 2 minutes at a
time.
NOTE: Do not run hot water for more than 2 minutes at a
time.
5. To stop the hot water, press HOT WATER again. The hot
water runoff will stop automatically when the preset amount
of water has been dispensed.
NOTE: The coffee system is factory-set to automatically
deliver approximately 1 cup (250 mL) of hot water.
of water has been dispensed.
NOTE: The coffee system is factory-set to automatically
deliver approximately 1 cup (250 mL) of hot water.
A. Clean button
A. Hot water and steam nozzle
A
A