Desa CGESBM Benutzerhandbuch
www.desatech.com
117191-01A
4
GROUNDING
INSTRUCTIONS
This stove is for use on 120 volts. The cord has a
plug as shown in Figure 2. An adapter is available
for connecting three-blade grounding-type plugs
to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to
a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
Figure 2 - Grounding Methods
Figure 3 - Electric Stove Control Panel
OPERATING
INSTRUCTIONS
Once the unit has been properly connected to a
ground electrical outlet, it is ready to operate.
Note:
Note:
Ensure the circuit breakers for power
supply are turned on.
CONTROL PANEL OPERATION
Controls are located on the back of the unit
(see Figure 3).
1. Main ON/OFF power switch: This switch is
located at the furthest right corner on the
control panel when looking at the back of
the unit. Turn the switch to ON and unit
will be ready to operate. The "|" indicates
ON and "O" indicates OFF.
2. Heater Switch and Control Dial: The
heater switch has a sun directly below it. To
turn the heater on, flip the Heater Switch
to ON position (the "|" indicates ON and
"O" indicates OFF). The Control Knob
has a thermometer below it. Turn the dial
clockwise past the number 8. You should
hear a small clicking sound indicating the
heater has started and heat will emit the
from the vents at the top of the unit. To
turn off heater, turn the temperature dial
counter clockwise past number 1 and flip
the Heater Switch to OFF position.
To increase the desired temperature, turn
the temperature dial clockwise towards
Number 8.
To decrease the desired temperature, turn the
temperature dial counter clockwise towards
number 1. The heater has a built-in thermo-
stat so it will shut off automatically once the
set temperature is reached. It will also turn on
automatically if the room temperature drops
below the set temperature on the dial.
Note:
When the heater is turned on for the
first time, it may release a slight, harmless
odor. This odor is a normal occurrence caused
by the initial heating of the internal heating
elements and should not occur again.
4. Flame Control Dial: This dial controls the
intensity of the flame.
Light Adjustment
Dial
Dial
Main Power Switch
Flame
Control Dial
Control Dial
Heater
Switch
Switch
Heat Control
Dial
Dial
Grounding Pin
Adapter
CLEANING AND
MAINTENANCE
WARNING: Always discon-
nect power and allow the heater
to cool before performing any
cleaning, maintenance or reloca-
tion of this heater. Turn controls
to OFF and remove plug from
outlet or turn off circuit breaker
to heater.
Turn off heater and circuit breaker to heater before
performing any cleaning and/or maintenance. Al-
low heater to cool completely.
BULB REPLACEMENT
WARNING: The halogen light
bulbs in your unit can become
extremely hot. Allow at least 10
minutes between turning off the
heater and removing the light
bulbs to avoid accidental burns.