Honeywell UC100 Benutzerhandbuch

Seite von 4
INSTALLATION INSTRUCTIONS
69-1444-5
UC100 Ultraviolet System
Replacement Bulb/Handle Assembly
APPLICATION
The UC100 Ultraviolet System Replacement Bulb/Handle 
Assembly is for use with the UV100 Ultraviolet System. See 
Table 1 for your model.
INSTALLATION
When Installing this Product…
1. Read these instructions carefully. Failure to follow them 
could damage the product or cause a hazardous 
condition.
2. Check the rating given in the instructions and on the 
product to make sure the product is suitable for your 
application.
3. Removal and replacement of the ultraviolet lamps can 
easily be done by the homeowner following these 
instructions. The homeowner can also call an 
experienced service technician.
4. After installation is complete, check out product 
operation as provided in these instructions.
CAUTION
Personal Injury Hazard. 
Power supply can cause electrical shock.
Disconnect power supply before replacing ultraviolet 
bulb(s).
Do not open base unit or lamp handle; there are no 
user-serviceable components inside.
WARNING
UV Light Hazard. 
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision. 
Never look at bulbs while illuminated.
View illumination only through light indicator located 
on lamp handle.
To prevent exposure to ultraviolet light, disconnect 
power to Ultraviolet System before servicing any part 
of heating and air conditioning system.
 
CAUTION
UV Lamp Burn Hazard. 
Harmful to bare skin. 
Can cause severe burns.
Disconnect power and wait 15 minutes before 
removing ultraviolet bulb(s).
CAUTION
Breakable Glass Hazard. 
Can cause personal injury.
Be careful when inserting bulb(s) into lamp base.
Wear protective gloves when handling bulb(s).