Frigidaire 318205302 Benutzerhandbuch

25

The door is heavy. For safe, temporary storage, lay the 

door flat with the inside of the door facing down.

Be sure the oven is unplugged and all parts are COOL 

before replacing the oven light bulb. Do not turn 

the oven light on during a self-cleaning cycle. High 

temperature will reduce lamp life.

1.  Open oven door completely (horizontal with floor - 

See Figure 1).

2.  Pull the door hinge locks on both left and right 

door hinges down from the oven frame completely 

towards the oven door (See Figure 2). A tool such as 

a small flat-blade screwdriver may be required.

3.  Firmly grasp both sides of oven door along the door 

sides (Do not use the oven door handle - See Figure 3).

4.  Close the door to the broil stop position (the oven 

door will stop into this position just before fully 

closing).

5.  With the oven door in the broil stop position, lift the 

oven door hinge arms over the roller pins located on 

each side of the oven frame (See Figure 4).

1.  Firmly grasp both sides of oven door along the door 

sides (Do not use the oven door handle - See Figure 3).

2.  Holding the oven door at the same angle as the 

removal position, seat the hook of the hinge arm over 

the roller pins located on each side of the oven door 

frame (See Figure 4). The hook of the hinge arms 

must be fully seated onto the roller pins.

3.  Fully open the oven door (horizontal with floor - See 

Figure 1).

4.  Push the door hinge locks up towards and into the 

oven frame on both left and right oven door hinges 

(See Figure 2) to the locked position.

5.  Close the oven door.

Door Hinge locations

with oven door fully open

Oven door

Around

Hinge

special door care instructions - Most oven doors 

contain glass that can break. 
Read the following recommendations:
1.  Do not close the oven door until all the oven racks 

are fully in place.

2.  Do not hit the glass with pots, pans, or any other 

object.

3.  Scratching, hitting, jarring or stressing the glass may 

weaken its structure causing an increased risk of 

breakage at a later time.

On some models an interior oven light will turn on 

automatically when the oven is opened. The oven light 

may be turned on when the door is closed by using the 

oven light switch located on the Electronic Oven control. 

The oven light bulb is covered with a glass shield held 

in place by a wire holder. THIS GLASS SHIELD MUST 

ALWAYS BE IN PLACE WHEN THE OvEN IS IN USE.
To Replace the Light Bulb:

1.  Turn the power off at the main source.

2.  Wear a leather-faced glove for protection against 

possible broken glass.

3.  Replace bulb with a 40 Watt appliance bulb only.

4.  For self-cleaning oven, press wire holder to one side to 

release glass shield, change bulb

and be sure to replace glass shield.