Hoshizaki KMS-1400MLH Benutzerhandbuch

1

1. Electrical connections must be made in accordance with the instructions on 

the "WARNING" tag, provided with the pig tail leads in the condensing unit 
junction box.

2. Electrical connections must meet national, state, and local electrical code 

requirements. Failure to meet these code requirements could cause severe 
injury to individuals or extensive damage to equipment.

3. Be sure to install a proper ground to the condensing unit. 
4. Power supply and ground wire to the icemaker are supplied from the 

condensing unit via the wire harness. Connect the icemaker and condensing 
unit using the wire harness supplied, or fabricate a wire harness using 
appropriate outdoor-rated 18 AWG wire. Use the wiring label or Fig. 8 as a 
reference when making connections.

• Electrical connections must be installed in accordance with applicable national, state, and 

local regulations.

• Usually an electrical permit and services of a licensed electrician are required
• The condensing unit requires an independent power supply. See the nameplate for proper 

voltage and breaker/fuse size.

• Power supply and ground wire to the icemaker are supplied from the condensing unit via 

the wire harness.

• The maximum allowable voltage variation is ±10 percent of the nameplate rating. 
• On single phase machines, the white lead must be connected to the neutral conductor of 

the power source. Miswiring results in severe damage to the icemaker. See Fig. 6. 

• On three phase machines, the transformer's voltage tap switch must be positioned to 

match incoming voltage at startup. See Fig. 7.

1. Icemaker
Power supply and ground wire to the icemaker are supplied from the condensing unit 
via the wire harness. Connect the icemaker and condensing unit using the wire harness 
supplied, or fabricate a wire harness using appropriate outdoor-rated 18 AWG wire.

To reduce the risk of electric shock, do not connect the power supply until after 
all wire harness connections have been made.

1) Route the wire harness from the  icemaker to the condensing unit.
2) Secure the wire harness to the condensing unit with the strain relief bushing provided 

(condensing unit accessory).