Manitowoc Ice K00214 Merkblatt

1.  The K00214 kit is used for installing 30" stacked units, Q-0800, Q-1000, QF-2200, and a single 30" S-series ice 

machine on a Manitowoc S-970 bin. 

2.  Installation (bin must be level before starting): 

A.  Remove existing foam tape from top of bin.   
B.  Place adapter on bin, as shown.  Locate foam tape from kit in the Figure A positions on top of bin, as shown.  

Note locations of narrow and wide tape. 

C.  Place fillers on adapter, as shown.  Make sure the two holes from the adapter and fillers are aligned on the side. 
D.  Using the fillers as templates, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum in bin.  Warning: 

Do not drill through interior liner.  Attach with 10-24 x .750” screws provided. 

E.  Apply foam tape to the edge of the fillers and on the front and back of the adapter between the fillers in the Figure 

B positions.  Note:  It is recommended to RTV intersections and along front inside edge of foam tape (see Figure 
B) to prevent water tracking. 

3.  Refer to ice machine installation manual for ice machine installation procedures. 
 

 
 
Manitowoc Ice, Inc. 

2110 South 26

th

 Street, P.O. Box 1720, Manitowoc, WI  54221-1720 USA                                                                                                                                       

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879                                                8013853                        
Web Site - www.manitowocice.com                                                                                                                                                      Rev. 05/12/04

Bin 

Fille

Wide Tape From 
Kit Both Sides

Adapter 

Filler 

Narrow Tape From 
Kit Both Sides 

Installer:  It is 
Recommended to RTV 
Intersections and Along 
Front Inside Edge of Foam 
Tape to Prevent Water 
Tracking 

Figure A 

Figure B