Mellerware ICM00IA Benutzerhandbuch

Seite von 6
PREPARING YOUR ICE MAKER FOR USE
When using electrical appliances, basic safety 
precautions should be followed to reduce the risk 
of fire, electric shock, and injury to persons or 
property. Read all instructions before using any 
appliance.    
 
SAFETY ADVICE:
-  Do not operate this appliance with a damaged  
   power cord. If the power cord is damaged,  
   it must be replaced by the manufacturer or its  
   service agent or a similarly qualified person in  
   order to avoid a hazard.
-  Ensure that the voltage on the rating label  
   corresponds with the voltage of the wall socket.   
   No other appliance should be plugged into  
   the same wall socket when using this appliance.   
   Ensure that the plug is fully inserted into the wall.
-  Do not allow the power cord to come into contact    
   with hot, rough or sharp surfaces and objects. 
-  Do not allow the power cord to hang over the  
   edge of the counter.
-  Do not use this appliance with plug adaptors  
   and extension cords. 
 
-  Switch off the appliance & remove the plug from  
   the wall socket before undertaking any cleaning  
   task or when the appliance is not in use.
-  This appliance is intended for household use  
   only. Do not use the appliance outdoors. 
-  Do not place this product in direct sunlight.
-  Ensure that there is a 10cm gap between the    
   unit and surrounding objects.
-  Do not use any other liquids to make ice-cubes  
   other than clean water.
-  Do not clean your ice maker with flammable  
   or hazardous fluids. The fumes can create a fire  
   hazard or an explosion and could be hazardous  
   to your health.
-  Do not tilt or turn the appliance over. This  
   appliance should remain upright at all times.
-  This appliance is not intended for use by  
   persons (including children) with reduced  
   physical, sensory or mental capabilities, or lack  
   of experience and knowledge, unless they have  
   been given supervision or instruction concerning
   use of the appliance  and are supervised during    
   use of the appliance by a person responsible
    for their safety.   
 
 
-  Children should be supervised to ensure that  
   they do not play with the appliance. 
-  Use the appliance in a well ventilated area.
-  Do not place the appliance on hot surfaces,   
   such as cooking plates, gas burners, ovens    
   or similar. 
   
 
 
    
CAUTION: In order to prevent overheating do not 
cover the appliance.
-  Do not use the appliance if it has fallen on the  
   floor, if there are visible signs of damage or if it  
   has a leak.
-  Do not pull on the power cord to remove the  
   plug from the wall socket. Do not use the power  
   cord to lift, pull or carry the appliance.
-  Always use the appliance on an even surface.
-  Do not touch the plug, power cord or appliance  
   with wet hands.
-  Do not submerge the plug, power cord or  
   appliance in water or any other liquid.
-  Only use this appliance for its intended purpose.
-  Only use the accessories provided with this   
   appliance. Using other accessories can cause  
   the appliance to malfunction.
-  Do not touch the evaporator while the appliance  
   is in use. 
 
 
 
 
 
 
 
     
OPERATING PROCEDURES & MAINTENANCE 
UNPACKING YOUR ICE MAKER:  
 
1.  Remove the exterior and interior packaging.  
     Check if ice basket and ice scoop are inside.  
     If any parts are missing, please contact our  
     customer service department.
2.  Remove the tape securing the ice shovel, ice  
     basket & ice scoop in place. Clean the tank &  
     ice basket.
3.  Put the ice maker on a level counter top away  
     from direct sunlight or any other sources of heat. 
4.  Ensure that the unit has a 10cm space on all   
     sides from surrounding objects.
5.  Allow the water to circulate through the  
     product until it indicates “ADD WATER”.
6.  Empty all water and refill the product with fresh   
     clean water.
7.  Only use cold water when using this product.
8.  To get larger, more dense ice bullets, use  
MW_ICM001A_IM.indd   3
2012/09/04   11:37:23 AM