Thomas & Betts BPLT15BSCR-B Benutzerhandbuch
STORAGE
(Refer to Fig 6)
4.3
When not in use, the tool
should be stored and
transported in the metal
case, to prevent damage
This case is suitable for
storing the tool, and its
accessories
Metal Case: size
22 3x16x5 1 inches,
(566x406x130 mm)
weighs 14 8 lbs (6,7 kg)
Fig. 6
29
TA03982 B Page 4 of 7
3.0
BATTERY USE
The tool is supplied with the batteries completely discharged; before use, fully charge the batteries using the charger supplied.
USING THE BATTERY CHARGER
3.2
Carefully follow the instructions in the battery
charger manual
charger manual
In order to use the batteries correctly,
please follow these rules:
• Use the battery until the automatic residual energy
please follow these rules:
• Use the battery until the automatic residual energy
display still has 1-2 red LEDs showing: this means the
battery is almost completely discharged and no loss in
the life of the battery has been produced
battery is almost completely discharged and no loss in
the life of the battery has been produced
• Be particularly careful when charging a new battery
the first 2-3 times in order to maximize the available
energy level
energy level
• Allow the battery to cool down to ambient temperature
prior to recharging
• Rest the battery charger for at least 15 minutes
between charges
4.0
MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with the following points,
should help to maintain the optimum performance of the tool:
should help to maintain the optimum performance of the tool:
THOROUGH CLEANING
4.1
Dust, sand and dirt are a danger for any hydraulic device
Every day, after use, the tool must be wiped with a clean
cloth taking care to remove any residue, especially close
to pivots and moveable parts
OIL FILL
4.2
Top off the oil, if necessary,
as follows:
- Remove the battery
- Remove the battery
- Place the tool in a vertical
position and remove the
filler cap (29) located
inside the battery housing,
taking care not to splash
any oil onto the housing
- Fill the reservoir to the top
- Replace the filler cap (29)
Fig. 5
34
BATTERY STATUS
(Refer to Fig 4)
3.1
Fig. 4
• After releasing the operating button, the residual battery
capacity is automatically displayed for 5 seconds on the
indicator (34)
indicator (34)
The number of LEDs illuminated indicates the residual
capacity:
capacity:
8 LEDs illuminated: Fully Charged
4 LEDs illuminated: 50% capacity
1 LED illuminated: Minimum charge
4 LEDs illuminated: 50% capacity
1 LED illuminated: Minimum charge
When replacing the battery, press the two points marked
with the word “PUSH” at the same time, remove the flat
battery from its housing and insert the new one
with the word “PUSH” at the same time, remove the flat
battery from its housing and insert the new one
USING THE BATTERY
3.3