JVC TH-C60 Benutzerhandbuch

NOTE

• Manufacturers’ codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

7 To set the manufacturer’s code

Slide the remote control mode selector
to TV.

Press and hold F TV.

Keep the button pressed until step 4 is finished.

Press ENTER.

Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).

Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.

“01” is the initial setting.

Release F TV.

If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.

7 Operation

Aim the remote control at the TV.

IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.

The following buttons are available:
F TV:

Turns TV on and off.

TV VOL +/–

Adjusts the volume.

TV/VIDEO

Selects the input mode (either TV or
VIDEO).

CH +/–

Changes the channels.

1-10, 0,

h10 (100+): Selects the channel.

TV RETURN

Alternates between the previously selected
channel and the current channel.

NOTE

• The operating buttons may differ depending on manufacturers.

The buttons described below are used on pages 14 and 15.

Remote
control mode
selector

Number

buttons

(play button)

Operating the TV

Manufacturer

Code

Manufacturer

Code

JVC

01*

Samsung

Hitachi

Sanyo

13, 14

Magnavox

Sharp

Mitsubishi

Sony

Panasonic

04, 11

Toshiba

Philips

Zenith

RCA

Operating external components with the remote control

TH-C60-40[J]7.book Page 14 Monday, February 27, 2006 11:25 AM