Viking F20470I EN Installationsanweisungen

CAUTION: If not using a duct cover, using screws

provided, make sure top mounting screws are secured
into soffit or cabinet framing. Use additional mounting

screws, if necessary.

Connect black to black, white to white, and the

green/bare wire under the green screw.

NOTE: Housing wiring must be properly installed for

wiring to be correct when wiring unit.

Replace electrical box cover. Make connection to

breaker box.

Slide spacer front over front lip. Push spacer rear up,

then slide back over rear lip.

Slide filter front over front lip. Push filter rear up, then

slide back over rear lip.

CAUTION: Secure vent hood to wall using screws

provided. Use additional mounting screws and wall

anchors, if necessary.

Text goe here.

Check damper for unrestricted movement, adjust if

necessary.

Attach transition to damper. Seal with aluminum tape.

Flip hood over and remove electrical box cover.

Insert 6” of electrical wiring through the top of vent hood

and secure using wiring restrain. Refer to local codes.

Slide duct over transition and tape around joint.

Installation

(VWH 10”H. Wall Hoods w/Standard Ventilator)

W A R N I N G

To reduce the risk of fire, electric shock, or injury
to persons, observe the following:

• Use this unit only in the manner intended by the

manufacturer. If you have any questions, contact
the manufacturer.

• Before servicing or cleaning unit, switch power off

at service panel and lock service panel to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such
as a tag, to the service panel.