Viking F21287A EN Benutzerhandbuch
33
1
-13
/16
”
(4.6 cm
)
1-1/2”x 3/4”
(3.8 cm) x (1.9 cm)
wood strip
1
5/16”
nut driver
Slot for
wood strip
2
5/16”
nut driver
Measure down 1-13/16 (4.6 cm) from desired height of
hood and secure 1-1/2” x 3/4” wood strip (provided
locally) to wall using screws provided.
Use additional mounting screws to secure hood to
wood strip.
3
5/16”
nut driver
5/16”
nut driver
CAUTION: Secure vent hood to wall using screws
provided. Use additional mounting screws and wall
anchors, if necessary.
CAUTION: If not using a duct cover, using screws
provided, make sure top mounting screws are secured
into soffit or cabinet framing use additional mounting
screws, if necessary.
32
Connect black to black, white to white, and the
green/bare wire under the green screw.
NOTE: Housing wiring must be properly installed for
wiring to be correct when wiring unit.
Replace electrical box cover. Make connection to
breaker box.
Assemble brackets to baffles and insert charcoal filters.
BLACK
BLACK
WHITE
WHITE
GREEN
BARE OR GREEN
8
1
1
2
9
10
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
1
2
3
11
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
1
2
3
13
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
1
2
3
12
1
2
1
3
4
1
2
3
5
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
Installation
(VWH 18”H. Wall & VCWH Chimney Wall Hoods)
Installation
(con’t)
(VWH 10” H./12”H. Wall Hoods w/Recirculating Kit)