Delta SIG110HL Benutzerhandbuch

MODELS

SIG80L / SIG110L / SIG110HL / SIG110DL

Page 2.

SUPPLIED ACCESSORIES

Part name

Appearance

Quantity

Grille

Tapping screw

(ψ 4x25)

Screw

#8-32x1/4”

Grille bracket screw

(M4x6)

Grille screw

(M4x30)

Nut

(M4x4.4)

Duct connector

Duct screw

(M4x12)

Suspension bracket I

13 (318.5)

Suspension bracket II

13”(318.5)

Grille bracket

GU24 base bulb lamp

(26W)

E12 base bulb lamp

(4W)

Inches (mm)

INSTALLATIONS

Attach Duct Connector

Option 1. Attach the duct connector from the outside, and
secure using the duct screw (M4X12).

Insert tab into

slot in housing

Duct screw(M4X12)

from Parts Bag

Option 2. Attach the duct connector from the housing can
inside, and secure using the duct screw (M4X12).

Pull existing ductwork

into Housing

Insert tab into slot

in Housing

Duct screw(M4X12)

from Parts Bag

Note: Remove the tape from the damper and adaptor before
installation.

1. Using suspension brackets

1-1. Sliding suspension brackets are available to allow the

housing to be positioned between joists up to a span of

1-2. Insert the suspension brackets into the channels on the

housing. Make sure the tabs face up as shown. (Fig. C)

1-3. Extend the suspension brackets to fit the width of the

joists. Hold the fan in place by wrapping the suspension
bracket tabs around the bottom of the joist. Make sure

the fan body is level and perpendicular to the joist. (Fig. D
& E)

1-4. Ensure that the distance between the ceiling and fan

body is appropriate for mounting the grille.

1-5. Secure the suspension brackets to the joists with nails or

by using the tapping screws (ψ 4x25) through holes near
nails.

1-6. Secure the suspension bracket to the fan body using the

screws (#8-32 x 1/4").

1-7. Follow steps 2 to 6 of the installation guide to complete

installation.

Suspension

Bracket II

Suspension

Bracket I

Body

Tab

Fig. C

Fig. D

Fig. E

9.68”

24”.