Frigidaire EI30WC55GS Benutzerhandbuch

9

9

9

9

9

The duct cover bracket should be installed against
the back wall and flush with the ceiling. This bracket
will hold the telescopic duct cover in place at the top
(this a extra accessory available not included with the
hood).
.
Secur

Secur

Secur

Secur

Secure the bracket to the wall:

e the bracket to the wall:

e the bracket to the wall:

e the bracket to the wall:

e the bracket to the wall:

• Align the marked centerline on the bracket with

the centerline on the wall.

• Mark 2 screw hole locations in the wall.
• Drill 5/16" pilot holes in the marked locations.
• Install wall fastener anchors.
• Drive wood screws, by hand, into the fastener to

allow anchors to expand. Remove the screws.

• Secure the bracket to the wall with wood screws

and/or fasteners.

Vertical centerline

Ceiling

Wall

If the duct will vent straight up to the ceiling:
• Use level to draw a line straight up, from the

centerline on the template to the ceiling.

• Measure at least 4 -3/4 ” from the back wall to

the circle center of an 8-½” hole on the ceiling.

If ductwork will vent to rear:

• Use a level to draw a line straight up from the

centerline on the template.

• Measure at least 23 - 3/4" (the measure might

vary dependig on the elbow used) above the
pencil line that indicates the bottom installation
height, to the circle center of an 8-½” diameter
duct hole (Hole may be elongated for duct elbow).

• The junction box is located on the top left side of

the hood.

• Wiring should enter the back wall at least 20"

above the bottom of the installation height, and
within 5-7/8" and 4-7/8"of the left side of the
centerline.

Horizontal straight

pencil line

Ceiling

4-3/4" circle

center to wall

8-1/2" dia. hole

FOR CEILING VENT DUCTING

FOR

WALL

VENT

DUCT

Circle center at 23 3/4"

above the marked bottom

pencil line.