Dacor RV30 Benutzerhandbuch

Seite von 12
3
Important Safety Instructions
before operating the raised vent, verify that pot 
• 
handles or other objects will not interfere with the 
raising and lowering of the vent intake. to prevent 
spillage and damage to the vent system, turn 
cookware handles to the side so that they will not 
be hit when the vent moves to the “up” position.
clean liquid spills immediately. if liquid enters the 
• 
vent intake, then turn off the blower, disconnect the 
power supply and carefully wipe up all liquid. see 
the Care and Cleaning section of this manual.
never operate the vent without the filters in place.
• 
Do not operate the blower if a flame or flare-up 
• 
develops. in the event of a flame, immediately 
turn off the blower. smother the flame or use an 
appropriate class dry chemical or foam-type fire 
extinguisher.
Do not set or rest any objects, including cookware,  
• 
on top of the vent top cap. Do not interfere with the 
movement of the vent intake in any way.
if the vent intake becomes jammed while being 
• 
raised or lowered, immediately press the up/
Down switch once to stop the intake motion, 
then disconnect the power supply. remove the 
obstruction, then restore power and press the up/
Down switch to continue raising or lowering the 
intake.
clean this appliance only as instructed in this 
• 
manual. use only the cleaners specified.
never leave a cooktop or range unattended during 
• 
use.
 warning
 warning
Operation
 warning
if the vent intake becomes jammed while being raised 
or lowered, immediately press the uP/DoWn key once 
to stop the intake motion, then disconnect the power 
cord. remove the obstruction, reconnect the power plug 
and press the uP/DoWn key to continue raising or 
lowering the intake.
 important
the direction of travel of the vent intake cannot be 
reversed while it is moving. the intake must complete a 
full up or down cycle before changing directions.
to operate the rv raised vent system when the vent 
intake is in its lowered position, press and release the 
uP/DoWn key on the control panel. the intake will take 
approximately ten seconds to reach its uppermost posi-
tion, where it will stop.
the blower will turn on automatically and run on the 
high speed setting. adjust the blower speed by pressing 
and releasing either the meDIum or loW keys. the fan 
speed may be changed whenever desired, as long as the 
vent intake is in the fully raised position. the blower will 
not operate if the intake is in any other position.
turn off the blower in one of two ways: press and release 
the oFF key or lower the vent by pressing and releasing 
the uP/DoWn key.
Operating Your Raised Vent
Parts the of raised Vent - shown raised
appearance varies with model number
top cap
intake 
grill
control panel
uP/DoWn
loW
oFF
meDIum
HIGH