Snapper RP217017BV Benutzerhandbuch

 

 

2.2.1.  ENGINE & BLADE 
(Choke Models) 
1.  Move fuel shut off valve to the “ON” position. 
See Figure 2.5. 

 

NOTE:  Stop the engine (and blade) by releasing the 

blade control. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

2.  Move engine speed control to the “Choke” 
position. See Figure 2.6. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

3.  Pull blade control against handle. 
4.  Pull rope start handle to crank engine. 
5. After engine starts, allow a brief warm-up until 
engine runs smooth. 

2.2.1.  ENGINE & BLADE 
(Electric Start Models) 
When the ignition key (Electric Start Switch) is turned 
to “START”, the engine will not crank and will not start 
unless the blade control is engaged! 
1.  Move engine speed control to the “Fast” (Rabbit) 
position. See Figure 2.3. 
2. Push primer button three times to start a cold 
engine.  NOTE: Primer should not be required to 
restart a hot engine. 
3.  Pull blade control against handle. 
4.  Turn key to the start position until engine starts.  
See Figure 2.3. 

NOTE: If after 5 seconds of cranking the engine does not 
start, release the key and attempt starting again after 
waiting for approximately 20 seconds. 

5.  After engine starts, allow a brief warm-up until 
engine runs smooth. 
 
2.2.2.  PROPELLING MOWER  
 

1. Start engine. Refer to Section “Starting & 
Operation”. 
2.  Move ground speed control to the desired speed 
position. See Figure 2.7. 
3.  Move wheel drive control against handle to 
engage wheel drive and propel mower forward. 
Forward speed can be adjusted while the mower is 
moving by changing position of the ground speed 
control. See Figure 2.7. 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 

Stop engine and blade by releasing the blade 

control. Stop forward motion of mower by releasing 
the wheel drive control.