NEC LCD1810X Benutzerhandbuch
Appendix
Español
Français
Deutsch
English
Italiano
Troubleshooting/Support
E - 24
Problem
Cheak These Items
Image is unstable,
- Signal cable should be completely attached to the
unfocused or
computer.
swimming is
- Use the OSM Image Adjust controls to focus and
apparent
adjust display by increasing or decreasing the Fine
Control.
When the display mode is changed, the OSM Image
Adjust settings may need to be re-adjusted.
- Check the monitor and your display card with respect
to compatibility and recommended signal timings.
- If your text is garbled, change the video mode to
non-interlace and use 60Hz refresh rate.
Control.
When the display mode is changed, the OSM Image
Adjust settings may need to be re-adjusted.
- Check the monitor and your display card with respect
to compatibility and recommended signal timings.
- If your text is garbled, change the video mode to
non-interlace and use 60Hz refresh rate.
LED on monitor is
- Power Switch should be in the ON position and
not lit (no green or
power cord should be connected.
amber colour can be - Make certain the computer is not in a power-saving
seen)
seen)
mode (touch the keyboard or mouse).
Display image is
- Use the OSM Image Adjust controls to increase or
not sized properly
decrease the H. Size.
- Check to make sure that a supported mode and signal
timing has been selected on the display card or system
being used. (Please consult display card or system
manual to change graphics mode or refresh rate.)
- Check to make sure that a supported mode and signal
timing has been selected on the display card or system
being used. (Please consult display card or system
manual to change graphics mode or refresh rate.)
No Video
If no video is present on the screen, turn the Power
button off and on again.
button off and on again.
CN912B-2/LCD1810X/78135322
00.5.26, 0:04 PM
39