GE ZIRS36N RH Benutzerhandbuch
3
Design Information
36" Stainless Steel Refrigerators, Freezers
Flush or
Semi-Flush
Enclosure
Installations
Semi-Flush
Enclosure
Installations
True Flush Installation
In a flush installation,
the refrigerator door
will align evenly with the front
face of adjacent cabinet doors.
The refrigerator blends into the
The refrigerator blends into the
surrounding cabinetry.
Semi-Flush Installation
These refrigerators
can also be installed
semi-flush into an enclosure
using the minimum cutout
width. The case trim creates a
frame around the opening.
Monogram built-in refrigerators and freezers can be
installed flush with typical 24-3/4" deep cabinetry.
installed flush with typical 24-3/4" deep cabinetry.
When installed semi-flush, the case trim will conceal
slight gaps around the enclosure. The refrigerator will
project forward approximately 3/4" beyond the front
face of surrounding cabinetry.
slight gaps around the enclosure. The refrigerator will
project forward approximately 3/4" beyond the front
face of surrounding cabinetry.
Enclosure
Cutout and
Product
Dimensions
Cutout and
Product
Dimensions
• To achieve a flush fit, the finished cutout width must be
at least 36" wide.
• In a semi-flush installation, the finished cutout must be
35-1/2".
• The electrical and water locations must be located
as shown for either type of installation.
*36" for a flush installation.
35-1/2" Min. for a semi-flush installation.
NOTE: Additional cutout width may be required when side
panels are used. Add side panel thickness to the finished
cutout to calculate rough-in width. See installation examples
on the following page.
panels are used. Add side panel thickness to the finished
cutout to calculate rough-in width. See installation examples
on the following page.
Advance Planning
Side Panel Requirements:
• Side panels are not required whenever the
• Side panels are not required whenever the
refrigerator or freezer is installed into an enclosure
or between pantry and oven cabinets.
or between pantry and oven cabinets.
• Side panels are required whenever the sides of the
product are exposed.
• Side panel sizes vary depending on the type of
installation being made.
To accomplish an attractive installation, you must:
1. Determine the need for side panels.
2. Determine side panel thickness.
3. Order matching side panels from the cabinet
1. Determine the need for side panels.
2. Determine side panel thickness.
3. Order matching side panels from the cabinet
manufacturer. Be sure to provide the exact dimensions.
0"
3/4"
*Shipped at 84" installation height.
Can be adjusted to 83-1/2"
or 84-1/2" with grille panel kits.
or 84-1/2" with grille panel kits.
75" From Floor
to Bottom
of Electrical
Area
84 1/2" max
83 1/2" min
Finished
Opening
Opening
*Finished Width
Electrical
Area
Area
5"
5"
3 1/2"
24 3/4" Total
Depth
Depth
Water Supply
3 1/2"
Wall View
2 1/2"
5"
6"
36" Frame to Frame
84"*
26-3/4"
Including
Tubular
Handles
Including
Tubular
Handles
35"
Case
Width
Case
Width
24-3/4"
Case
Depth
Case
Depth