GE ZICP720 Benutzerhandbuch
12
Installation Instructions
SECURE REFRIGERATOR TO CABINETRY
Whenever possible, perform this step for anti-tip
security, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
security, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
• Drill hole in trim and drive screw through the trim
into adjacent cabinet.
• Follow the same procedure on the opposite side.
9
ALTERNATE ANTI-TIP PROCEDURE
The refrigerator must be secured to prevent tipping.
The anti-tip brackets cannot be used on metal
wall studs. Use this Alternate Procedure to secure
the refrigerator against tip-over whenever metal wall
studs are encountered and there is a soffit.
wall studs. Use this Alternate Procedure to secure
the refrigerator against tip-over whenever metal wall
studs are encountered and there is a soffit.
• Use a 3/16
″ bit to drill eight evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16
″ bit to drill pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4
should be centered in the soffit or a 3/4
″ min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
securely fastened to cabinets on both sides.
• Install eight (4 on each refrigerator) 1-1/2
″ drywall
screws into the pilot holes.
8
Top Case Trim
Install Eight 1-1/2
″ Drywall Screws Through Trim
and Into Soffit or 3/4
″ Min. Wood Brace
3/4
″
Min.
Side View
Top Case Trim
Drive Screws Through Case Trim
and Into Adjacent Cabinets
Top Case Trim
INSTALL GRILLE PANEL
TWO PEOPLE ARE REQUIRED TO INSTALL
THE GRILLE PANEL.
THE GRILLE PANEL.
• Push all four hinges on the grille panel (F) to the
open position.
• Hold the unified grille panel against the left side of the
opening. Drive 2 screws through the hinge and into the
support bracket. Install the right side hinge. Then install
the center hinges.
support bracket. Install the right side hinge. Then install
the center hinges.
• Grasp grille panel at the center and pull down to close.
The panel should align evenly with the beveled side
of the door.
of the door.
NOTE: To adjust the grille panel backward or forward,
loosen the 2 attachment screws on all 4 hinges. Slide
the grille panel outward or to the back. Tighten the screws.
loosen the 2 attachment screws on all 4 hinges. Slide
the grille panel outward or to the back. Tighten the screws.
10
Install 2
screws
Grille Panel