Blomberg KQD 1360E Benutzerhandbuch

Seite von 323
EN
15
The water filter must be removed as 
shown in the figure when it is going to 
be replaced or when it will no longer 
be used and by-pass cover must be 
attached. It must be made sure that Ice 
Off mode is active before taking it out.
A
 Caution: Water filter cleans some 
foreign particles in the water. It does not 
purify water from microorganisms.
A
 Caution: Ice Off button must always 
be pressed during replacement of the 
water filter or installing the by-pass 
cover.
Prior to first use of Water 
Dispenser
C
 Water mains pressure must not be 
below 1 bar.
C
 Water mains pressure must not be 
above 8 bars.
C
 Pumps must be used in case the 
supply water pressure drops below 1 bar 
or if a jug is going to be used.
C
 Water system of the refrigerator must 
be connected to the cold water line. It 
must not be connected to hot water line.
C
 No water may be obtained in the 
initial operation of the refrigerator. This 
is caused by the air in the system. To 
discharge air from the system, press 
Dispenser latch for periods of 1 minute 
until water comes from the Dispenser.  
Water flow may be irregular in the 
beginning. Irregular water flow will be 
normalized after the air in the system is 
discharged.
C
 At the initial startup of the refrigerator 
approx.12 hours must pass before cold 
water can be obtained.
C
 Water mains pressure must be 
between 1-8 bars for the operation of 
Ice/Water Dispenser smoothly. For this, 
check that 1 glass of water (100 cc) can 
be filled in 10 seconds.
C
 The first 10 glasses of water should 
not be consumed.
C
 Approximately the first 30 cubes 
of ice to be obtained from the Ice 
Dispenser must not be used. 
C
 Always use the water filter when a jug 
is not being used.