GE JBP26AP Benutzerhandbuch

(See Cleaning Guide)

Proper care 

 cleaning are

 so 

 

 will give

 efficient and satisfactory service.

Your 

 is vented through 

 

 directions carefully in

duct located under the right rear

 

 

 range   

 safe

surface unit. 

 the duct often.

and 

proper maintenance.

 porcelain enamel cooktop is

sturdy but breakable   misused.
This 

 is acid-resistant.

However, any 

 spills with 

high acid content (such as 

 juices,

 or vinegar-) should not be

permitted to remain on the finish.

The area 

 the range   

equipped with   bottom 

 can

 reached easily for cleaning by

removing 

 bottom drawer. To

remove, 

 drawer 

 

 the

way, 

 

 the 

 and remove

it. To replace. insert 

   back

 drawer 

 stop on 

 

● 

Make sure 

 is cool.

● 

Lift 

 right rear surface unit.

● 

Remove drip pan/trim ring.

● 

Lift out oven vent 

To replace:

● 

Place the part over the oven vent

located below the cooktop with

opening   the duct under the

The oven 

 (bulb) is covered

with   

 removable cover which

is 

 place with   bail-shaped

wire. Remove oven door, if desired,
to reach cover easily.

. Hold hand under cover so it
doesn’t fall when released. With
fingers of same hand, firmly push
back wire bail until it clears cover.
Lift 

 cover. DO NOT REMOVE

ANY SCREWS.

. Replace bulb with 40-watt home
appliance 

● 

Place it into groove of lamp

 

 

 

 if 

 to

round opening in the drip pan.   is

receptacle. Pull wire bail forward to

insert easily. Let front of drawer

important that the duct is in the

center of cover until   snaps into

 then 

 in to 

correct position so moisture and

place. When in place, wire holds

vapors from the oven can be

cover firmly. Be certain wire bail is

 during oven use. NOTE:

in depression in center of cover.

Never cover the hole in the oven

. Connect electric power to range.

vent duct with aluminum foil or

1

any other material. This prevents
the oven vent from working

properly during any cooking 

Clean the area under the drip

 

 often. Built-up soil,

To REMOVE door, open to BROIL
position. or where 

 

 hinge

catch slightly. Grasp door at sides:
lift door up and away from hinges.

To REPLACE, 

 door at sides.

Line 

 door 

with hinges and push

door firmly into place.

your oven lamp bulb, disconnect
the electric power for your range
at the main fuse or circuit
breaker panel. Be sure to 

 the

lamp cover and bulb cool
completely before removing or
replacing them.

 

 may 

catch

-

fire.

To make cleaning easier, tilt-lock
units lift up and lock in the up
position, and plug-in units
are removable.

After   

 the tilt-lock unit or

removing a plug-in unit, remove
the drip 

 rings and clean

them according to directions in the
Cleaning Guide. Wipe around the
edges   the surface unit opening.
Clean the area below the unit.
Rinse all washed areas with
a damp cloth or sponge.