Frigidaire FGES3045KB Benutzerhandbuch

12



See Recommended Setting for Surface Element table on 

page 10.

 (all models)

The cooktop has 2 or 3 SINGLE radiant surface elements: 

the left rear position (Figures 1, 2 & 3), the right rear 

position (Figures 1 and 2), and the right front position 

(Figures 1 and 3). The left rear element may also be used 

with the Bridge element (Model C only - Figure 3).

1.  Place correctly sized cookware on the radiant surface 

element.

2.  Push in and turn the surface control knob in either 

direction to the desired setting (Figure 4). Start most 

cooking operations on a higher setting and then turn 

to a lower setting to fi nish cooking. Each surface 

element provides a constant amount of heat at each 

setting. A glowing red surface heating area extending 

beyond the bottom edge of the cookware indicates 

the cookware is too small for the surface heating 

area.

3.  When cooking has completed, turn the surface 

control knob to OFF before removing the cookware.

Figure 1 - Model A

Figure 2 - Model B

Figure 3 - Model C

Radiant surface elements may appear to have cooled 

after they have been turned OFF. HE (Hot Element) 

message (Models B & C) or the hot surface indicator 

light (Model A) will turn ON and will continue to glow 

until the glass cooktop has cooled down to a moderate 

level. The glass surface may still be hot and burns 

may occur if the glass surface is touched before the 

indicator light has turned OFF. The message may 

remain on even though the controls are turned OFF.

wrappings on cooktop when it is in use. These 

items could melt or ignite. Potholders, towels or 

wooden spoons could catch fi re if placed too close to 

the surface elements.

cooktop. If these items melt on the cooktop they will 

damage the ceramic cooktop.



The surface “Element On” indicator lights will glow 

when one or more elements are turned on. A quick 

glance at these indicator lights when cooking is fi nished 

is an easy check to be sure all surface elements are 

turned off.

Figure 4 - Control knob shown is typical only.