Frigidaire FGEF306TMF Benutzerhandbuch

16

Í

The surface elements cannot be activated when the 

Lockout feature is active (see the section: The electronic 

surface element control (ESEC)).

The 

 pad controls the Lockout feature. The Lockout 

feature automatically locks the oven doors, the control 

panel and the cooktop. It does not disable the Minute 

Timer or the interior oven lights.
To activate the Lockout feature

1.  Press and hold 

 for 3 seconds.

2.  After 3 seconds “Loc” and “Control” will appear, a 

beep will sound, “UPPER”, “LOWER” and “DOOR” will 

fl ash in the display. Once the oven door is locked the 

“DOOR” will stop fl ashing and remain on along with 
the “Loc”, “Control” and the   icon will appear.

1.  Press and hold 

 for 3 seconds. A beep will sound. 

The “UPPER”, “LOWER” and “DOOR” will fl ash in the 

display until the oven door has completely unlocked and 
the   icon will disappear.

2.  The unit is again fully operational.

The TIMER ON.OFF pad controls the Timer feature. The 

Timer serves as an extra timer in the kitchen that will 

beep when the set time has run out. It does not start or 

stop cooking. The Timer feature can be used during any 

of the other oven control functions. Refer to “Minimum 

and Maximum Control Pad Settings” for time amount 

settings.
To set the Timer (example for 5 minutes)
1. Press 

TIMER ON.OFF. “-- --” will appear in the 

display.

2.  Use the number pads to set the desired time in the 

display; press 5.

3. Press 

START. The time will begin to count down with 

“5:00” in the display.

Note: If START is not pressed the timer will return to the 

time of day after 25 seconds.
4.  When the set time has run out, “End” will show in 

the display. The clock will sound with 3 beeps every 5 

seconds until TIMER ON.OFF is pressed.

1. Press 

TIMER ON.OFF. The display will return to the 

time of day.

The ADD 1 MINUTE pad is used to set the Add 1 Minute 

feature. When the ADD 1 MINUTE pad is pressed, 1 

minute is added to the Timer feature if this feature is 

already active. If the Timer feature is not active and 

the ADD 1 MINUTE pad is pressed, the Timer feature 

will become active and will begin counting down from 1 

minute.

The DELAY START and SELF CLEAN pads control 

the Silent Control operation feature. The Silent Control 

operation feature allows the oven control to be operated 

without sounds or beeps whenever necessary. If desired 

the control can be programmed for silent operation and 

later returned to operating with all the normal sounds 

and beeps.
To change control from normal sound operation to 
silent control operation

1.  To tell if your range is set for normal or silent 

operation press and hold DELAY START. “-- --” will 

appear and “DELAY” will fl ash in the display. After 

6 seconds “bEEP On” or “bEEP OFF” will appear in 

the display.

2. Press 

SELF CLEAN to switch between normal sound 

operation and silent operation mode. The display will 

show either “bEEP On” or “bEEP OFF”.

Note: If “bEEP On” appears, the control will operate with 

normal sounds and beeps. If “bEEP OFF” appears, the 

control is in the silent operation mode.
3. Press 

START to accept the change or press CANCEL 

to reject the change.

Note: The control will always beep at the end of a minute 

timer and will beep when a set temperature has been 

reached, even if the control is set to silent operation.