Frigidaire FKGF309MDSJ Benutzerhandbuch

01. Place the metal clamp on the hose end.
02. Connect the hose to the oven connector and tight the clamp.
03. Place the other clamp on the opposite hose end and connect it to the 

pressure regulator. Tight the clamp.

04. Bolt the pressure regulator to the gas cylinder carefully.
05. After the installation, check if there is any gas leak, using soap or liquid 

detergent foam

If you have any doubt or need to buy 
any accessory for the installation, 
please contact our authorize service.

01. This range was designed for 

use with LP gas

.

02. Always use a pressure 

regulator exclusive for your gas 
range. The lack of pressure 
regulator might cause excess 
of pressure and leak of gas. 
Always check for the validity of 
the pressure regulator. Hose 
and regulator should be 
replaced every 5 years.
Technical specification of the 
pressure regulator:
• Pressure: 200 mm C. A.
• Max. consumption: 2 kg/h

03. Always use a PVC hose to 

work from -20ºC to  100ºC. Be 
sure that hose:
• does not have joins.
• does not go on the back of 

the gas range neither close 
to the hot air exits.

• its less than 125cm long.

04. If possible, install the gas 

cylinder outside the kitchen, in 
a place protected and with air 
flow.

05. Use a 1/2"metallic hose to 

connect to the gas range using 
a L coupling connector.

06. Only use a plastic hose when 

this one does not go on the 
back of the gas range.

L coupling

connector

Connector