Frigidaire 316135917 Benutzerhandbuch

Changing Cooktop

and/or Oven Lights

(if equipped)

Be sure the range is unplugged and all parts are COOL before

replacing the surface or oven lights. Wear a leather-faced glove for protection

against possible broken glass.

To Change the Cooktop Light (some models)

1. Turn power off at the main source or unplug the range.

2. Remove Phillips® Head screws (2) that secure the light cover and then lift

the light cover off.

3. Remove bulb by rolling back and up. Install the new bulb by sliding down

and rolling forward into place.

4. Re-install light cover and secure with Phillips® Head screws (2).

To Change the Oven Light (some Self Cleaning Models)

On some models, the oven light automatically turns on when the door is

opened. Some models have a switch located on the control panel to turn on

the light. The oven light is located at the rear of the oven and is covered with

a glass shield held by a wire holder. The glass shield must be in place whenever

the oven is in use.

To replace the oven light:

1. Turn electrical power off at the main source or unplug the range.

2. Press wire holder to one side to release the glass shield.

3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder into place.

5. Turn power back on again at the main source (or plug the range back in).

6. The clock(if equipped) will then need to be reset. To reset, see Setting the

Clock and Minute Timer in this Owner's Guide.

General Cleaning

To Remove and Replace Oven Door

To Remove Oven Door:

1. Open the door.

2. Remove screws located on the inside of the oven door near the hinges A

(one on each side.)

3. Close the door to the quarter-open position. Grasp the door firmly on both

sides and lift up and off the hinges.

4. To clean oven door, follow the instructions provided in the cleaning chart

under General Cleaning

To Replace Oven Door:

1. Be sure the hinge arms are in the quarter-open position. Be careful if pulling

the hinges open by hand. The hinges may snap back against the oven frame

and could pinch fingers.

2. Hold the door at the sides near the top. Insert the hinge arms into slots at

the bottom of the door.

3. Hinge arms must go into the range slots evenly. The hinge arms should be

inserted into the bottom corners of the door as far as they can go.

4. If the door is not in line with the oven frame, remove it and repeat the above

steps.

The door is heavy. For

safe, temporary storage, lay the door

flat with the inside of the door facing

down.