Whirlpool STANDARD CLEANING GAS RANGE Benutzerhandbuch

Seite von 28
8
OVEN USE
Odors and smoke are normal when the oven is used the first few 
times, or when it is heavily soiled.
IMPORTANT: 
The health of some birds is extremely sensitive to 
the fumes given off. Exposure to the fumes may result in death to 
certain birds. Always move birds to another closed and well 
ventilated room.
Electronic Clock/Timer
(on some models)
Display
When power is first supplied to the range, “12:00” will appear on 
the display.
If “12:00” appears at any other time, a power failure has 
occurred. Reset the Clock. See “Clock” section. 
Any time the Timer is not in use, the display will show the time of 
day.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the Timer is off.
1.
Touch CLOCK. 
The colon will flash during Clock programming.
2.
Touch the “up” or “down” arrow pads to set the time of day.
The time can be changed in either small or 10-minute 
increments by touching a pad briefly or by touching and 
holding a pad. 
3.
Touch CLOCK. The colon will stop flashing when the Clock is 
active.
Timer
The Timer can be set in hours and minutes up to 9 hours, 
50 minutes, and it counts down the set time. The Timer does not 
start or stop the oven.
To Set:
1.
Touch TIMER. 
The small green light next to the Timer button will flash during 
programming.
2.
Touch the “up” or “down” arrow pads to set length of time.
3.
Touch TIMER.
Colon will begin flashing, and the Timer will begin counting 
down.
To display the time of day while the Timer is counting down, 
press CLOCK. Time of day will be displayed until the Timer 
button is pressed or until the Timer reaches zero.
When there is one minute of time remaining, the display will 
begin counting down in seconds and a “beep” will sound.
When the Timer reaches zero, the display will show “0:00” 
and four short tones will sound. A series of four tones will 
sound until the Timer is canceled.
To Cancel:
 Touch TIMER once in the Timer mode.
Aluminum Foil
IMPORTANT: 
Do not line the oven bottom with any type of foil, 
liners or cookware because permanent damage will occur to the 
oven bottom finish.
Do not block or cover the oven bottom vents.
Do not cover entire rack with foil because air must be able to 
move freely for best cooking results.
To catch spills, place foil on rack below dish. Make sure foil is 
at least 1 in. (2.5 cm) larger than the dish and that it is turned 
up at the edges.
Positioning Racks and Bakeware
IMPORTANT:
 Never place food or bakeware directly on the oven 
door or bottom. Permanent damage will occur to the porcelain 
finish.
RACKS
Position racks before turning the oven on. Do not move racks 
with bakeware on them. Make sure racks are level. For best 
performance, cook on one rack. Place the rack so the top of food 
will be centered in the oven. To move a rack, pull it out to the stop 
position, raise the front edge, then lift out. 
Porcelain 
enamel-on-
steel or cast 
iron
See stainless steel or cast iron.
Stainless steel
Heats quickly, but unevenly.
A core or base of aluminum or copper 
on stainless steel provides even 
heating.
1. Timer
2. Display
3. Increase
4. Decrease
5. Clock
COOKWARE
CHARACTERISTICS
5
4
1
3
2
FOOD
RACK POSITION
Frozen pies, large roasts, turkeys, 
angel food cakes
1 or 2
Bundt cakes, most quick breads, yeast 
breads, casseroles, meats
2