KitchenAid W10284348A Installationsanweisungen

1. Install the water filter near the cold water supply pipe under 

the kitchen sink to filter the cold water.

IMPORTANT: Be sure to allow a minimum clearance of 
1½" (3.8 cm) under the filter system for removing the filter 
cartridge.

Make sure that the water filter assembly is installed in the 
upright position.

NOTE: For unique installations contact a licensed plumber.

In Massachusetts a licensed plumber is required and the 
Commonwealth of Massachusetts Plumbing Code 248-CMR shall 
be adhered to.

2. Attach the supplied water filter mounting ring and screw at 

the recommended location.

3. Attach filter to the mounting ring.

1. Make connection to the cold water supply line. 

■

A leak-tight connection to the ¼" flexible codes approved 
water supply line must be provided. 

■

Check local codes for type of connection required.

■

Flexible codes approved water supply line must be cut with a 
tubing cutter so the ends are concentric and without burrs.

NOTE: It is recommended that the cold water line be soft water.

NOTE: Use the quick connect stem and/or elbow adapter fittings 
in the combination needed for your installation configuration.

1. Attach the supplied 

³⁄₈" to ¹⁄₄" stem or ³⁄₈" to ¹⁄₄" elbow quick 

connect adapter fitting to the yellow water filter inlet 
connection by pushing the quick connect fitting past the 
o-ring until you hit the backstop. 

2. Connect the flexible codes approved water supply line (not 

provided) from the home cold water supply pipe to the quick 
connect adapter fitting you just installed on the filter inlet 
(yellow) side of the water filter.

3. Pull tube to ensure it is secured.

Push in collet to release tubing. With collet held in, pull tubing 
straight out.

1. Attach the supplied 

³⁄₈" to ¹⁄₄" stem or ³⁄₈" to ¹⁄₄" elbow quick 

connect adapter fitting to the blue water filter outlet 
connection by pushing the quick connect fitting past the 
o-ring until you hit the backstop.

2. Connect another piece of flexible codes approved water 

supply line to the quick connect adapter fitting you just 
installed on the filter outlet (blue) side of the water filter.

A

B

C

B

A

A