Schumacher PIC-150-USB Benutzerhandbuch

• 4 •

Plug the device into the inverter AC outlet or USB port.

Turn the device on.

To disconnect, reverse the above procedure.

NOTE: You may hear a “buzzing” sound being emitted from 

inexpensive sound systems when operated with the inverter. This 

is due to ineffective filters in the sound system’s power supply. 

Unfortunately, this problem can only be resolved by purchasing a 

sound system with a higher quality power supply or higher quality filter.

Your average automobile or marine battery at full charge will provide 

an ample power supply to the inverter for approximately 3 hours when 

the engine is off. The actual length of time the inverter will function 

depends on the age and condition of the battery and the power 

demand being placed by the device being operated with the inverter.
If you decide to use the inverter while the engine is off, we 

recommend you turn OFF the device plugged into the inverter and 

disconnect the inverter’s plug from the 12-volt accessory outlet before 

starting the engine. To maintain battery power, start the engine every 

2 to 3 hours and let it run for approximately 30 minutes to recharge 

the battery.
Although it is not necessary to disconnect the inverter when turning 

over the engine, it may briefly cease to operate as the battery voltage 

decreases. While the inverter draws very low amperage when not in 

use, it should be unplugged to avoid battery drain.

The GREEN LED automatically lights when plugged into a 12-volt DC 

source and the RED LED will light under the following conditions:

When the power input from the vehicle’s battery drops to 

approximately 10 volts, low battery shutdown occurs and 

inverter shuts off. Solution: recharge or replace the battery.
When the power input from the vehicle’s battery exceeds 15 

volts, high voltage protection occurs. Solution: reduce the 

voltage range to between 12 volts and 14 volts.