3M eg3 Benutzerhandbuch
Overview of running a study
053-644, Rev E
Page 31
eg4 & eg3
31
Running and operating
your dosimeter
your dosimeter
The focus of this chapter is to discuss the procedures for running and operating the Edge and
includes positioning, calibrating, and viewing the Edge measurements.
The list below is a brief overview of the steps for running a study.
Figure 4-1: Quick help list for running a study
CHAPTER
4
Quick Help List: typical dosimetry session
1. Turn the dosimeter on and check your battery power.
2. Reset the dosimeter.
3. This will clear out all of the data history before your study begins to ensure you have
1. Turn the dosimeter on and check your battery power.
2. Reset the dosimeter.
3. This will clear out all of the data history before your study begins to ensure you have
sufficient memory space on the Edge.
4. Set-up your study parameters via DMS.
5. Calibrate the dosimeter.
6. Attach the dosimeter for your personal noise study.
6. Attach the dosimeter for your personal noise study.
7. Press the Run/Stop button to start the study.
8. When you are ready to end your study, press the Run/Stop button to stop the study.
9. Review your results either on the meter or download to DMS for further analysis
8. When you are ready to end your study, press the Run/Stop button to stop the study.
9. Review your results either on the meter or download to DMS for further analysis
(graphs/charts, saving and printing).