Intel SE7501WV2 Benutzerhandbuch

For example, Modem applications typically use a DCD signal. In this case the user would use a 
DCD-configured adapter and set the jumper block as shown in Figure 5. 

The floppy disk controller (FDC) in the SIO is functionally compatible with floppy disk controllers 
in the DP8473 and N844077. All FDC functions are integrated into the SIO including analog 
data separator and 16-byte FIFO. The SE7501WV2 server board provides two separate 
interfaces for the floppy disk controller. The first is a SSI compliant 36-pin connector, and the 
second is through the high-density 100-pin floppy / front panel / IDE connector.  

Note: Using both interfaces in a common configuration is not supported. 

One external PS/2 port located on the back of the baseboard is provided for either a keyboard 
or a mouse. A PS/2 Y-cable can be used to provide simultaneous support for both a keyboard 
and mouse. 

The Super I/O contains functionality that allows various events to control the power-on and 
power-off the system. 

The SE7501WV2 server board incorporates an Intel

®

 3 Volt Advanced+ Boot Block 28F320C3 

Flash memory component. The 28F320C3 is a high-performance 32-megabit memory 
component that provides 2048K x 16 of BIOS and non-volatile storage space. The flash device 
is connected through the X-bus from the SIO.