AT&T MLS-6TM Benutzerhandbuch

Doorphone

#606

Alert

Identifies the extension or extensions that ring when someone

Extensions

presses the button on a doorphone.  Each doorphone can have up to five alert

extensions.  The doorphones can have five individual alert extensions or they
can share alert extensions.  Use procedures #604 and #605 (Doorphone 1 and
Doorphone 2 Extensions) to assign doorphone extensions.

Valid Entries:   ✓  

1 = Not an alert extension

2 = Doorphone 1 alert extension
3 = Doorphone 2 alert extension
4 = Both doors alert extension

1.   

Press [ Feature  ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 6 ] [ 0 ] [ 6 ].  The
display reads:

DoorPhneAlert

Extension:

2.   Enter the first alert extension.  For example, to select extension 10, press

[ 1 ] [ 0 ].  The display reads:

DoorPhneAlert 10

1 No Alert

3.   To change the alert status, enter the appropriate setting as listed above.

For example, to make this extension an alert for both doorphone exten-
sions, press [ 4 ] . The display reads:

DoorPhneAlert 10

4 Doors 1 and 2

To select another alert extension, press [ Next Item ] or [ Prev Item ] until the extension number
shows on the display.  Repeat step 3.

If you press [ Next Proc ] , the system skips procedure #728, Sys-

tem Reset—Programming Saved and returns to procedure #101, System Date.
To use procedure #728 at this point, you must enter [ # ] [ 7 ] [ 2 ] [ 8 ] .

✓ 

= Factory Setting

To go to the next procedure:  [ Next Proc ]

To go to 

a 

specific procedure:   [ # ] [ x ]  [  x  ] [  x ]

To go to the previous procedure:  [ Prev Proc ] 

(where XXX is the procedure number)

To return data to the factory setting: [ Remove ]

To exit system programming:  [ Feature ] [ 0 ] [ 0 ]

System Programming  3-33