Tanaka TOB-120 Benutzerhandbuch

 

 

 
www.tanakapowerequipment.com                            5                                              custsvc@tanaka-ism.com 

Preparation for Operation 
 

WARNING: Failure to follow all instructions could result in personal injury and/or damage to unit. Remove 

wire from spark plug before attempting any adjustment or assembly procedures. 

 

Instructions contained in this manual apply to several models. Use the instructions that apply to your unit. 

Fuel Mixture 
 

IMPORTANT: 2-cycle engines require that oil be mixed with fuel. Refer to Fuel in Operation section of this 

manual for recommended mixture. 

 

 

Place handle (throttle lever up) into position on joint pipe holder with 

notch on end of handle against handle stopper. Secure to joint pipe 

holder with wing head bolt, lock washer, two plain washers, and Hair 

Pin. Attach throttle cable to carburetor bracket. 

Place handle (throttle cable down) into position on clutch case. Be sure 

flat of handle is set in notch of handle stopper. Secure to clutch case 

with 8 x 30 bolt, lock washer, and two plain washers. Attach throttle 

cable to carburetor. 

 
Gear Housing 
Check gear housing for proper level of grease prior to operation. See Lubrication and Maintenance section for 
proper procedures.