Desa CDCFTN Benutzerhandbuch

111244-01A

Install and use fireplace with care. Follow all local codes. In the
absence of local codes, use the latest edition of The National Fuel
Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY  10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA  02269

There are four optional remote controls that can be purchased
separately for Remote-Ready Models only:
• wall switch

• hand-held ON/OFF remote

• wall thermostat

• hand-held thermostat remote

See Accessories, pages 36 and 37.

This fireplace has a pilot with an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS/pilot is a required feature for vent-free
room fireplaces. The ODS/pilot shuts off the fireplace if there is not
enough fresh air.

This fireplace has a piezo ignitor. This system requires no matches,
batteries, or other sources to light fireplace.

Thermostat-Controlled models have a thermostat sensing bulb and
a control valve. The thermostat will automatically modulate the heat
output to maintain a consistent room temperature. This results in
greater fireplace comfort. This can also result in lower gas bills.

1.

Remove fireplace and hood from carton. Log is wrapped and
inside fireplace. Do not remove at this time.

2.

Remove all protective packaging applied to fireplace for
shipment.

3.

Make sure your fireplace includes one hardware packet.

4.

Check fireplace for any shipping damage. If fireplace is dam-
aged, promptly inform dealer where you bought fireplace.

Tools Required:

• Phillips screwdriver

• slotted screwdriver

• 5/16" hex wrench

• scissors

1.

Lift fireplace screen up and pull out to remove (see Figure 2).
Set screen aside until installation has been completed.

2.

Cut two plastic straps to remove the log from the firebox cavity.
Set log aside.

3.

An optional blower is available. See Accessories, pages 36 and
37. Install optional blower now. Follow installation instruc-
tions provided with blower and see page 12 for Remote-Ready
Models or page 13 for Thermostat-Controlled Models.

4.

Locate four black phillips sheet metal screws in hardware packet.

5.

Slide hood between louver and firebox top and align screw holes.

6.

Insert screws as shown in Figure 3. Tighten screws firmly.

Screen

Shoulder Screw

Hood

Sheet Metal
Screws

Firebox Top

Louver