2WIRE g700 Benutzerhandbuch

 Jsl

© 2002 Avaya Inc All Rights Reserved

IP Enabling Siemens
Hicom with Avaya
MultiVantage Solutions

LPH 11-27-02

3

The configuration used to test performance of this solution was established in an Avaya Lab
setting within the guidelines and use parameters allowed in the user licenses acquired with the
equipment and software listed below.

Avaya MultiVantage Software

1.2

Avaya S8300 Media Server

213.0

Avaya G700 Media Gateway

3.12

Avaya™ 4612 IP Phones

46XXCommon.V36

Avaya™ 4624 IP Phones

46XXCommon.V36

Avaya MM710 T-1 Interface

Firmware version 5

Siemens Hicom 300 30 EP

Release 9006.5

DSC80 Processor

Firmware version D961-D

TMDN64P T-1 Interface  (Q2484-X)

Firmware version D467-C

Optiset E Digital Advanced Plus Phones

Model 69671

Software:

1.     Avaya MultiVantage Software

Release 1.2 

or newer

2.     G700 Media Gateway Firmware

Release 3.12

or newer

3.     S8300 Media Server Software

Release 213.0

or newer

Hardware:

1.  MM710 DS1 Circuit pack.  Installer needs to determine the number of trunks cards

that will be needed for traffic requirements. Consideration must be made for the
available slots and resources of the Hicom.

2. 

T-1 Interface cable.  Connects the MM710 T-1 RJ45 interface port or the TN464 DS1
circuit pack to the Hicom.  The actual cable needs to be custom built.

For this application to be successful, the intended switch must have:

1.  Available slots for the T-1 boards.
2.  Available purchased software ports for the T-1 spans.
3.  T-1 boards must be compatible to software version.
4.  If software or port capacities need to be upgraded, there are two options.

a.  Siemens can be contacted and they will upgrade the system.
b.  The software on DAT tape is purchased from Siemens or a vendor.  The customer

loads the software.