Polycom 7000 Benutzerhandbuch

 

Call Server Configuration

Polycom, Inc. 

242

See also: 

Dial string 

Enter a dial string to test. Then click Test. For SIP, the dial string should 
always specify the schema prefix (sip or sips). For example: 

sips:rbruce@10.47.7.9 

Caller site 

Select a site in order to set the four caller site variables: 
•

CALLER_SITE_NAME 

CALLER_SITE_DIGITS 

CALLER_SITE_COUNTRY_CODE 

CALLER_SITE_AREA_CODE 

These variables can’t be set directly and are display only. 

CALLER_H323ID 

Test caller’s H323-ID or blank. 

CALLER_E164 

Test caller’s H.323 E.164 alias or blank. 

CALLER_TEL_URI 

Test caller’s SIP tel URI or blank. 

CALLER_SIP_URI 

Test caller’s SIP sip URI or blank. 

VMR/Lync Conf ID

This field specifies the return value of the function 
“getConferenceRoomOrID()”, and is only populated when the dial rule 
simulates an outbound call to an endpoint from a conference based on a VMR 
or Lync conference ID.
If the dial rule simulates a call to a VMR or Lync conference ID or a dial-in call, 
this field is blank.

Test route output 

Displays the results of applying each rule (including its preliminary, if any) to 
the dial string. 
For instance, testing the dial string example shown above against the default 
dial plan might result in the following: 

#1:SipAlias[sips:rbruce@10.47.7.9] is not registered. H323-ID[rbruce] 
is not registered. 
#2:The room [rbruce] does not exist. 
#3:No entry queue is found. 
#4:Domain [10.47.7.9] is not within our administration. 
#5:The call was accepted by this dial rule. 

Final result 

Displays the final outcome of the dial rule processing. The final outcome for 
the example above would be: 

Transformed dial string is [sips:rbruce@10.47.7.9]. The call was 
accepted by dial rule #5.