Western Telematic RSM-16DC Benutzerhandbuch

Warnings and Cautions:

Installation Instructions

Secure Racking

If Secure Racked units are installed in a closed or multi-unit rack assembly, they may 
require further evaluation by Certification Agencies.  The following items must be 
considered.

1.  The ambient within the rack may be greater than room ambient.  Installation 

should be such that the amount of air flow required for safe operation is not 
compromised.  The maximum temperature for the equipment in this environment is 
45°C.  Consideration should be given to the maximum rated ambient.

2.  Installation should be such that a hazardous stability condition is not achieved due 

to uneven loading.

Input Supply

1.  Check nameplate ratings to assure there is no overloading of supply circuits that 

could have an effect on overcurrent protection and supply wiring.

2.  When installing 48 VDC rated equipment, it must be installed only per the following 

conditions:

A.  Connect the equipment to a 48 VDC supply source that is electrically isolated 

from the alternating current source.  The 48 VDC source is to be connected to 
a 48 VDC SELV source.

B.  Input wiring to terminal block must be routed and secured in such a manner 

that it is protected from damage and stress.  Do not route wiring past sharp 
edges or moving parts.

C.  A readily accessible disconnect device, with a 3 mm minimum contact gap, 

shall be incorporated in the fixed wiring.

Grounding

Reliable earthing of this equipment must be maintained.  Particular attention should 
be given to supply connections when connecting to power strips, rather than direct 
connections to the branch circuit.

No Serviceable Parts Inside; Authorized Service Personnel Only

Do not attempt to repair or service this device yourself.  Internal components must be 
serviced by authorized personnel only.