OWI IC6 Benutzerhandbuch

 
 
 

 

 
SPEAKER SPECIFICATIONS: 
 

System Description 

2-Way Co-Axial Speaker 

2-Way Co-Axial Speaker 

High Frequency Driver 

1/2".Hard Dome Tweeter Ferrofluid 
cooled 

1/2" Hard Dome Tweeter Ferrofluid 
cooled 

Low Frequency Driver 
 

5-1/4" Paper Coated Woofer with 
Polyurethane Surround 

6-1/2" Paper Coated Woofer with 
Polyurethane Surround 

Impedance 

8 Ohms 

8 Ohms 

Sensitivity (1 Watt, 1 Meter) 

85.2 dB 

86.5 dB 

Frequency Response 

70Hz - 20kHz 

45Hz - 20kHz 

Power Rating 

20 W Nominal, 40 W Max.  

25 W Nominal, 50 W Max. 

Recommended Amplifier 
Power 

40 Watts 

50 Watts 

Dispersion 140

o

 120

o

 

Size 

8" x 2-1/2 

9" x 2-1/2" 

Cut Out Size 

6-5/8" 

7-11/16" 

 
INSTALLATION: 
 
Speaker Placement 
 

Before installing your OWI speakers, consider the placement carefully, taking into effect the location of 
electrical, plumbing and other fixtures. 

 

Placement in Ceiling 
 

OWI speakers should be ideally located above the primary listening area. 

 
Placement in Wall 
 

Optimum sound will be achieved when your OWI speakers are installed at ear level or slightly higher and the 
listening area is no closer to the speakers than the distance between the speakers themselves. 

 
Mounting your OWI Speakers 
 

Determine the best area to mount your OWI speakers. It will be necessary to run your speaker wires to that 
location. This location must be free of obstructions, such as electrical conduits, HVAC ducts, or water lines. 

 

Be sure the mounting surface is between 3/8 and 1 1/4 inches thick, and there is at least a 2 3/4 inch clearance 
behind the mounting surface and no wall studs or other objects block the back of the speaker. 

 

Remove the round cardboard disc from the template supplied and keep it for later use as a paint mask, if you 
decide to paint your speakers.