Cisco Systems 2960-S Benutzerhandbuch
26-5
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
Chapter 26 Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring LLDP, LLDP-MED, and Wired Location Service
•
•
•
•
•
•
•
Default LLDP Configuration
Configuration Guidelines
•
If the interface is configured as a tunnel port, LLDP is automatically disabled.
•
If you first configure a network-policy profile on an interface, you cannot apply the switchport
voice vlan command on the interface. If the switchport voice vlan vlan-id is already configured on
an interface, you can apply a network-policy profile on the interface. This way the interface has the
voice or voice-signaling VLAN network-policy profile applied on the interface.
voice vlan command on the interface. If the switchport voice vlan vlan-id is already configured on
an interface, you can apply a network-policy profile on the interface. This way the interface has the
voice or voice-signaling VLAN network-policy profile applied on the interface.
•
You cannot configure static secure MAC addresses on an interface that has a network-policy profile.
•
You cannot configure a network-policy profile on a private-VLAN port.
•
For wired location to function, you must first enter the ip device tracking global configuration
command.
command.
Table 26-1
Default LLDP Configuration
Feature
Default Setting
LLDP global state
Disabled
LLDP holdtime (before discarding)
120 seconds
LLDP timer (packet update frequency)
30 seconds
LLDP reinitialization delay
2 seconds
LLDP tlv-select
Disabled to send and receive all TLVs
LLDP interface state
Disabled
LLDP receive
Disabled
LLDP transmit
Disabled
LLDP med-tlv-select
Disabled to send all LLDP-MED TLVs. When
LLDP is globally enabled, LLDP-MED-TLV is
also enabled.
LLDP is globally enabled, LLDP-MED-TLV is
also enabled.