Amtrol 200-l Merkblatt

PLUG

AIR VALVE

DOME

Figure 1

DRAIN PLUG

STAND

DOME

Figure 2

MARK

Figure 3

DIP

TUBE

Figure 4

This Product, like most Products under 

pressure, may over time corrode, weaken and 

burst or explode, causing serious or fatal injury, leaking or flooding 

and/or property damage. To minimize risk, a licensed professional 

must install and periodically inspect and service the Product. A drip 

pan connected to an adequate drain must be installed if leaking or 

flooding could cause property damage. Do not locate in an area 

where leaking could cause property damage to the area adjacent to 

the appliance or to lower floors of the structure.

1.  Isolate tank from system.
2.  Release system pressure from tank.
3. Remove air valve core to bleed remaining air charge  

(Figure 1).

4.  Remove drain plug (Figure 2).
5.  Disconnect system connection.
6.  Mark mating flanges in order to match when re-assembling 

(Figure 3).

7.  Remove bolted upper flange and dip tube/hose.

8.  Attached to the upper flange is the bladder support and 

dip tube/hose (Figure 4). Replace the dip tube/hose with 

the new one provided in package.

9. Using a pump, remove any remaining water inside of 

bladder.

10.Using a chain block, lift bladder out of the tank with a  

twisting motion.

NOTE:  Inspect for shipping damage and notify freight carrier or store where purchased immediately if damage is present.  To avoid risk of personal 

injury and property damage, if the product appears to be malfunctioning or shows signs of corrosion, call a qualified professional immediately.  Current 

copies of the Product manual can be viewed at www.amtrol.com.  Use proper safety equipment when installing. 

SYSTEM

CONNECTION

DIP TUBE/FLANGE ASSEMBLY

DRAIN

PLUG/

COUPLING

AIR 

VALVE

DIP

TUBE/

HOSE

OLD

BLADDER