A&D GP-102K Benutzerhandbuch

 

 76

C. Entering the density of a liquid. 

  Two ways to set the density of a liquid are available in the function table, Liquid density 

input (ldin): by entering the water temperature or by entering the density directly. 

• Enter the water temperature (ldin 0) 
  The water temperature currently set (unit:

°C, 

factory setting : 25

°C) is displayed.   

 

  Use the following keys to change the value. 

RE-ZERO key   

To increase the temperature by one degree. (0-99

°C) 

MODE key   

To decrease the temperature by one degree. (0-99

°C) 

PRINT key   

To store the change, display    end    and return to the density mode 
(the condition of step1, (2) Selecting a parameter to set). 

CAL key   

To cancel the change and return to the density mode (the condition 
of step 1, (2) Selecting a parameter to set). 

The relation between the water temperature and density is shown below. 
 

 

 

 

 

 

 

 

 

• Enter the density directly (ldin 1)  
  The density currently set (unit : g / cm

3

, factory 

setting : 1.0000g / cm

3

) is displayed.   

   

  Use the following keys to change the value. 

RE-ZERO key   

To set the value of the digit selected. 

SAMPLE key 

To select the digit to change the value. 

PRINT key   

To store the change, display    end    and return to the density mode   
(the condition of step1, (2) Selecting a parameter to set). 

CAL key  

To cancel the change and return to the density mode  (the 
condition of step1, (2) Selecting a parameter to set). 

 
(4) Outputting the density. 

After all the necessary parameters have been set, press 
the SAMPLE key to output the density calculated.