Combi 8040 Benutzerhandbuch
Pull out on latch plate. If belt slides freely through latch plate (fig. g), the locking
clip MUST be used (see “Locking Clip” section).
clip MUST be used (see “Locking Clip” section).
- For rear-facing, use the locking clip to secure the lap belt (see “Locking Clip”
section).
- For forward-facing, use the locking clip to secure the lap/shoulder belt.
Some combination lap/shoulder belts with free sliding latch plates may be
converted into an “automatic locking mode”. Always use the belt lock-off with
these belt systems.
converted into an “automatic locking mode”. Always use the belt lock-off with
these belt systems.
(fig. g)
Combination Lap/Shoulder Belt with Free Sliding Latch Plate
50
Vehicle seat belts with locking latch plates
(fig. h)
normally hold a car seat
tightly. However in some cases, the locking latch plate on some seat belts
may slip and loosen after being buckled on car seat if positioned at a certain
angle. If this happens, flip the latch plate over and re-buckle. Test installation
again to see if this works. If not, move car seat to another seating location.
may slip and loosen after being buckled on car seat if positioned at a certain
angle. If this happens, flip the latch plate over and re-buckle. Test installation
again to see if this works. If not, move car seat to another seating location.
(fig. h)
Flip
Combination Lap/Shoulder Belt with Locking Latch Plate
8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 51